New Start is a 100% Petroleum product, that mixes completely with all your petroleum-based and
synthetic lubricants. It does not contain any additives such as Teflon, zinc, or lithium so it will not leave
any unwanted deposits, or have any reaction with ingredients in such oils as hydraulic oil.
New Start will save you money by decreasing down time and repairs and part replacement; and by
providing you better fuel efficiency as well as greatly prolonging the life of your machinery.
New Start Prevents Metal on Metal contact by helping bearings and gears to retain oils at shutdown.
It ensures a protective layer of oil guarding your machine at start up..
This Eliminated the #1 cause of wear in otherwise well maintained engines thus decreasing
maintenance costs and down time. This benefit has been confirmed time and again through oil analysis.
New Start improves oil viscosity so it helps your oil to do its job, decreasing friction and reducing heat
build up caused by friction. It also allows the oil to maintain its integrity and continue to provide the
protection your machines need, even in long or hot running conditions. Since energy is conserved from
friction loss it is translated into better fuel economy.
New Start helps seals stay flexible and helps stop leakages. This increases oil pressure,
New Start is proven to need fewer amps to turn engines over even in colder weather. This is due to the
keeps oils cleaner and helps eliminate oil from entering the combustion chamber. New Start
will reduce or eliminate blow by, increase fuel efficiency and therefore helps protect our
environment for our future generations.
retained lubrication of engine parts at shutdown.
It has been used as an injector cleaner (mixed at 0.1%) and for tools such as u-joint pullers where other
oils dissipate off the threads.
New Start has been used in radicons and gearboxes as well as in mobile equipment. By truckers in all
hubs, transmission (but not in no-slips) rear ends and engines. By HD Equipment mechanics in motors,
transmissions, final drives, chain drives, hydraulics, planetary drives... New Start can be used anywhere
petroleum products are needed. New Start has been used with synthetic oils at a 10% ratio.
More New Start can be used depending on heat and load conditions but is generally used in a 25%
concentration. It is used at a lower concentration of 10% in hydraulics, two strokes and automatic
transmissions. It can also be mixed at 10-20% with greases to increase penetration and life.
For best results use New Start with new oil. It is imperative that New Start is added to fresh oil
on first use, as there may be metal filings if your previous oil was not adequately doing the job
of preventing metal on metal contact.
Save your money during the economic crisis.
Get Better gas mileage with New Start today.
You are visitor